SuperSeal30 Gloss 5 Gallon

$164.99
free shipping with ground services
Color

SuperSeal30 can be used for Stamped Concrete, Stamped Cement, Decorative Cement, Bricks, Acid Stained Cement, Concrete Stains, and Exposed Aggregate. SuperSeal enhances the natural color of your Concrete Brick Pavers and Cement with a "wet" look.
SuperSeal30 can be applied with a 1/2" roller cover. You cannot use a sprayer.

SuperSeal30 will help sand erosion reducing the amount of weeds.

One coat is recommended. Coverage is about 100 feet per gallon or 500 feet per five gallon.

One coat will result in a high gloss sheen depending on porosity of brick. Extra coats will result in a higher gloss.

This Product is not VOC Compliant in Every State

Click here for a VOC Compliant Product

Note: Super Seal 30 is not suggested for Clay Pavers.

Super Seal 30 Comes in Clear and Brown Tinted

Super Seal 30 in Clear on Exposed Aggregate

Super Seal 30 Clear

Super Seal 30 in Brown Tinted on Exposed Aggregate

Super Seal 30 Brown Tinted

Ask a Question or Post a Picture...
You are guest ( Sign Up ? )
or post as a guest
Loading comment... The comment will be refreshed after 00:00.
  • We will reply to your comment shortly
    ConcreteSealerStore · 11/15/2013
    Jerry, any roller will work but we like the rollers that look like a "sponge". 1/2 to 3/4 inch.
  • We will reply to your comment shortly
    Jerry Guthrie · 11/14/2013
    What type roller do you advise for application?
  • We will reply to your comment shortly
    ConcreteSealerStore · 09/02/2013
    Thanks for the nice review!!
  • We will reply to your comment shortly
    Scott Palfreeman · 09/01/2013
    I did quite a bit of research online after buying some terrible products at Home Depot and Lowes. I decided to try Super Seal 30 based on the 30% solids spec and frankly, a lot of good reviews. It was even better than I expected. Take the time to do a good job on the preparation and you will be blown away by the results. I did a stamped concrete patio that I thought was beyond repair (with our brutally wet/cold winters in Seattle). I liked it so much that I decided to do the aggregate driveway and I'm equally as impressed. This product is awesome. Only a little more than the other junk and so much better.
  • We will reply to your comment shortly
    ConcreteSealerStore · 08/22/2013
    It depends on the other sealer type an chemical makeup.
  • We will reply to your comment shortly
    Mandi · 08/22/2013
    I have another sealer that we tested on a corner of our brick paver stone patio. It does not give a glossy look like we wanted. Can we continue to use the sealer we already have and then put the Super Sealer 30 on top?

    These bricks have never been sealed.
  • We will reply to your comment shortly
    ConcreteSealerStore · 07/15/2013
    Chuck, what county is that?
  • We will reply to your comment shortly
    Chuck · 07/15/2013
    I live about 30 miles east of LA........zip code is 91709.....is that shippable for you?
  • We will reply to your comment shortly
    ConcreteSealerStore · 07/14/2013
    Chuck, you cannot use either in your area. You can use the SuperSeal VOC ([url]SuperSealVOC-Semi-Gloss-5-Gallon.html[/url]) for CA unless you are in the LA area. If you are in the LA area than we cannot send you any of our sealers:
  • We will reply to your comment shortly
    Chuck · 07/13/2013
    I am resealing some stamped/colored concrete that was sealed shortly after it was poured just over a year ago. I live in Southern California. Could you please educate me on the difference/benefit, etc between your 25 and 30 product. Also, am I required to use a low VOC product in Ca? Thanks.
  • We will reply to your comment shortly
    ConcreteSealerStore · 07/12/2013
    It will seal the pavers. I would use a general concrete cleaner and a pressure washer for the prep.
  • We will reply to your comment shortly
    Janet · 07/10/2013
    I have very old pavers some are discolored with a white color from plant chemicals won't wash off. My question is what prep will I need to do to prepare these pavers and will this treatment waterproof them the pavers.
  • We will reply to your comment shortly
    Jerry Biche · 07/08/2013
    Are there any dealers in the Albany New York area
  • We will reply to your comment shortly
    ConcreteSealerStore · 06/19/2013
    This is from over application. Get a solvent called xylene and spray the bubbles late in the evening when the sun goes down. They should go away.
  • We will reply to your comment shortly
    Jose Rodriguez · 06/17/2013
    I recently applied super seal 30(fathers day) on my patio,the day was overcast 70degree no rain.. I had waited 24-30 after power washing area. Today it was very hot in the after noon and I noticed bubbles? I put on 2 light coats used 3/4 of a 5 gallon on a 550 sq ft area. #1 Is there anything I can do now? #2 Over the next few days it is going to get hot will this problem get worse?

    Should i try to add some shade at this point(card board) ? patio gets hot by 3-pm
  • We will reply to your comment shortly
    ConcreteSealerStore · 04/29/2013
    Mac, the SuperSeal30 would be your best choice for this.
  • We will reply to your comment shortly
    Mac Caradine · 04/28/2013
    Two years ago a contractor pour a patio and used a stamp board, then applied dry power color to the concrete before it dried. Then the next day he washed off the excess powered and then applied Kure and Seal 30 as the sealer. Some of the concrete is starting to show where the color has worn. I want a high gloss wet look. What do you recommend?

    Mac
  • We will reply to your comment shortly
    ConcreteSealerStore · 04/24/2013
    mhkaighn, you can just seal over top of it.
  • We will reply to your comment shortly
    ConcreteSealerStore · 04/24/2013
    Denny, I would use the SuperSeal30
  • We will reply to your comment shortly
    Denny · 04/23/2013
    I have a stamped concrete patio, brownish color. What would be the best sealant to buy to re-seal it this summer?
  • We will reply to your comment shortly
    michael kaighn · 04/22/2013
    If I seal my stamped concrete pool deck with super seal 30. When I seal again in 3 years can I seal over top or does the old sealer have to be removed?
  • We will reply to your comment shortly
    ConcreteSealerStore · 04/18/2013
    I will probably be okay as long as the sealer is able to penetrate.
  • We will reply to your comment shortly
    Steve Brannon · 04/17/2013
    Will SuperSeal30 be alright to seal an outdoor concrete dining table that has been dyed and sanded by hand with 220 grit? I will also want to apply a beeswax after sealing?
  • We will reply to your comment shortly
    ConcreteSealerStore · 08/23/2012
    Hazing can happen form many reasons and typically is from over application or trapped moisture. Typically it is trapped moisture. I would apply a little solvent such as xylene to the affected areas. it should remove the hazing.
  • We will reply to your comment shortly
    erickj · 08/22/2012
    After two heavy coats of super seal I am still seeing a little haze. The drive was power washed with a 3000 psi washer and dried for days. I waited about two to three weeks before the second coat was applied. It was june when it was done so temp was good. Could it be a problem with the aggergate or with the sealer or either?
  • We will reply to your comment shortly
    ConcreteSealerStore · 06/01/2012
    The only way to fix you issue is to remove the failed sealer with a stripper and start over: Concrete Sealer Stripper ([url]Concrete-Sealer-Remover.html[/url])
  • We will reply to your comment shortly
    Matt · 05/31/2012
    I am looking to re-seal my stamped concrete patio that was installed a year ago. The color is supposed to be a deep and rich burgundy color but white/gray colors have overtaken many areas. I attempted to re-emulsify that sealant by rolling on two coats of Xylene. When wet, the color is correct but once it dries the white/gray reappears in affected areas. I was under the advice to remove the previous sealer (unknown) by wiping Xylene on the surface with a rag then applying a new sealer. Would the SuperSeal30 gloss permanently darken these spots (color is correct when wet)and be an appropriate fix?
  • We will reply to your comment shortly
    ConcreteSealerStore · 05/21/2012
    It should work but I have never heard of anything called "textured skin"
  • We will reply to your comment shortly
    joe v · 05/21/2012
    I'm looking to apply a sealer for the first time since the concrete was installed 3 years ago. It was sealed initially. The description of the installation was called a "textured skin". I would like to enhance the highlights of the concrete. Would you recommend this product?
  • We will reply to your comment shortly
    ConcreteSealerStore · 04/16/2012
    Sorry but there is not any dealers in your area. We can ship to you with.